Vernier CBL Made Easy Manual do Utilizador descarregar pdf (Página 15)

CBL Made Easy! 11

Step 3: Putting it All Together

Now you are ready to get your hardware set up. This is the easy part. At the base of the CBL are two ports.

The left port is the communications port. This connects the CBL to the calculator via the black calculator

link cable. Be sure to push the cables firmly in when connecting the two components.

There are four jacks located along the top and the left of the CBL unit in which you can plug Vernier or TI

probes. They are labeled CH1, CH2, CH3, and Sonic. You should use the lowest channel available. The

Sonic port is used only for the Motion Detector. If the order code for Vernier sensors ends with the

extension “-DIN,” (a 5-pin round plug) then it requires a DIN-BTA adapter. For more information about

adapters, refer to Appendix B.

Step 1:

Plug the black link cable into the link port on the

bottom of the CBL and TI graphing calculator.

CH1 CH2

Step 2:

Plug the CBL-DIN

adapter into Channel 1

of the CBL.

CH1 CH2

Step 3:

Connect the sensor to the

CBL-DIN adapter.

The right port allows you to connect an AC adapter (order code IPS). This will prolong battery life when doing

experiments indoors.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Sem comentários

Vernier CBL Made Easy Manual do Utilizador Página 15